Model: TOUCH1CHYELLOW
A small touch square that glows yellow when you press it with your finger and can pass a signal (touch works capacitively).
This module remains on after contact and only goes out when it is touched (can therefore be used as on/off switch).
The modu..
€3.00
Ex Tax:€2.48
Model: TTP223B
A 1 channel touch module.
Specifications:
Voltage: 2.0 - 5.5VDC (on the Vcc and GND)
1 LED to show the status of the touch.
1 put pin for the touch status (SIG pin)
Dimensions: 24 x 24mm
Note: The sensor can o..
€2.50
Ex Tax:€2.07
Model: TTP223BRED
A 1 channel touch module.
Specifications:
Voltage: 2.0 - 5.5VDC (on the Vcc and GND)
1 LED to show the status of the touch.
1 output pin for the touch status (I/O pin)
Option for high/low output and function as Reset bu..
€1.00
Ex Tax:€0.83
Model: TTP224
A 4 channel touch module.
Specifications:
Voltage: 2.4 - 5.5VDC (on the Vcc and GND)
4 LEDs to show the status of the touch.
4 output pins for the touch status
Dimensions: 35 x 29 mm
Note: The module may be delivered with separate..
€3.00
Ex Tax:€2.48
Model: TTP229
A 16 channel touch module. Specifications:
Voltage: 2.4 - 5.5VDC (on the Vcc and GND)
16 output pins for touch status
Possible to read the pins serially (SCL and SDO) Note: This is not I2C!
Dimensions: 49 x 65mm..
€4.00
Ex Tax:€3.31
Model: TOUCHSENSORMOD
This is a simple touch sensor, you can adjust the sensitivity with the potentiometer...
€2.50
Ex Tax:€2.07
Model: RCWL-1604
With this sensor a distance can be measured easily. The sensor is compatible with the HC-SR04...
€2.75
Ex Tax:€2.27
Model: GY-US42
A digital ultrasonic sensor that works with I2C communication.
Specifications:
Detection range: 20~640cm
Supply voltage: 3-5.5V DC
Signal voltage: 3-5.5V
Current:
3.3V: 2.7mA (50mA peak)
5.0V: 4.4mA (100mA peak)
..
€9.50
Ex Tax:€7.85
2-4 Weeks
Model: HC-SR04
With this ultrasonic sensor you can easily measure a distance.
To use the sensor with Arduino see this page: Ultrasonic Sensor HC-SR04 with Arduino Tutorial
The sensor works standard with the trig/echo, but it is also possible to modify the sen..
€3.00
Ex Tax:€2.48
2-4 Weeks
Model: HY-SRF05
With this ultrasonic sensor you can easily measure a distance. This sensor can also be used in a 3-pin configuration, where the OUT pin and GND pin must be connected.
To use the sensor as an HC-SR04 with Arduino see this page (leave the OUT pin un..
€3.25
Ex Tax:€2.69
Model: RCWL-1005
With this sensor a distance can be measured easily. The sensor is software compatible with the HC-SR04...
€3.00
Ex Tax:€2.48
Model: RCWL-1605
With this sensor a distance can be measured easily. The sensor is software compatible with the HC-SR04...
€3.00
Ex Tax:€2.48
Model: RCWL-1633
With this sensor a distance can easily be measured. Software-wise the sensor is practically compatible with the HC-SR04, however it works with a single pin for both the trigger and the echo. In addition, the receiver and transmitter can be colored by..
€5.00
Ex Tax:€4.13
Model: RCWL-1670
This ultrasonic sensor makes it easy to measure distances. This version has waterproof transmitter and receivers with a rubber seal, the module can be made waterproof with well-placed holes (for example in an enclosure). The sensor is software compat..
€6.50
Ex Tax:€5.37
Model: US-100
With this digital ultrasonic sensor with built-in temperature sensor one can easily measure a distance. Due to the built-in temperature sensor, the distance is corrected based on the ambient temperature, which gives more accurate measurements. In add..
€4.50
Ex Tax:€3.72
Model: UMW-DS18B20
A small but accurate temperature sensor in a TO-92 package. This is a cheaper variant of the original DS18B20...
€1.00
Ex Tax:€0.83
Model: UMW-TMP36GT9Z
A small but accurate temperature sensor in a TO-92 package. This is a cheaper variant of the original TMP36...
€1.50
Ex Tax:€1.24
Model: SH-LOGGER
An RTC shield for the TinyPICO, TinyS2/S3/C6 or ProS3 development boards. Furthermore, the shield has an SD card slot, two STEMMA QT/Qwicc connectors and a connector for a Li-ion/Li-Po battery (module has no charging circuit). The button on the modul..
€13.75
Ex Tax:€11.36
Model: UVSENSORMOD
With this module you can easily measure the UV light intensity indoors and/or outdoors. The module provides an analog output signal.
Specifications:
Supply voltage: 3.3-5V DC
Maximum current consumption: 0.1mA
Average current consumption..
€5.00
Ex Tax:€4.13
Model: SW-18010PMOD
This module can detect vibration. In the black component on the module there is a spiral that touches the casing with a vibration on the component.
The sensitivity can be set with the potentiometer.
Pin description:
VCC: 3.3-5V DC
GND: mi..
€2.00
Ex Tax:€1.65
Model: SW-420MOD
This module can detect vibration. In the blue component on the module there is a rod that no longer touches the housing when there is a vibration on the component.
The sensitivity can be set with the potentiometer.
Pin description:
VCC: 3.3..
€2.00
Ex Tax:€1.65
Model: VL53L0X
With this very small VL53L0X Time-of-Flight sensor you can easily measure a distance using the refelection of light.
Specifications:
Voltage (power supply and signal): 3.3-5V DC
Detection distance: 50-1200mm (standard), 50-2000mm (with opt..
€5.75
Ex Tax:€4.75
Model: VL53L1X
With this very small VL53L1X Time-of-Flight sensor you can easily measure a distance using the reflection of light. With the built-in level converter, the module can be used with both 3.3V and 5V microcontrollers.
Specifications:
Supply..
€6.50
Ex Tax:€5.37
Model: VL53L1X-COV
With this very small VL53L1X Time-of-Flight sensor you can easily measure a distance using the reflection of light. With the built-in level converter, the module can be used with both 3.3V and 5V microcontrollers. This version comes with an optical c..
€7.25
Ex Tax:€5.99
Model: VL6180
With this Time-of-Flight sensor you can easily measure a distance using the reflection of light. With the built-in level converter, the module can be used with both 3.3V and 5V microcontrollers...
€3.50
Ex Tax:€2.89
Model: WATERLVLSENSOR
A water level sensor that allows you to measure the height of water in a container for example.
Has an analog output with which the level can be determined roughly.
Specifications:
Voltage: 3.3-5V DC (+ and -, is listed on printed ci..
€1.50
Ex Tax:€1.24
Model: DFROBOT-SEN0562
This waterproof digital ambient light sensor is well suited for outdoor use. In addition, the sensor also has 50/60Hz light noise suppression to ensure stable and reliable measurements...
€10.00
Ex Tax:€8.26
Model: JSN-SR04T
With this water-resistant ultrasonic sensor you can easily measure a distance in a moist environment. It works just like an HC-SR04. The sensor with wire is water resistant.
To use this sensor with Arduino see this page: How to Use an HC-SR04 Ultr..
€9.00
Ex Tax:€7.44
Model: RCWL-1655
The RCWL-1655 is a waterproof ultrasonic ranging module with an integrated transceiver and receiver. The sensor (transmitter/receiver (black part)) is waterproof from the front...
€5.00
Ex Tax:€4.13
Model: WS-14810
Brand: Waveshare
A scanner that can scan both barcodes and QR codes. It can be read out via UART or via USB. In the second case, the module acts as a keyboard...
€37.00
Ex Tax:€30.58
Model: WS-13694
Brand: Waveshare
With this module a fingerprint can be read with a PC, Raspberry Pi, Arduino or other microcontroller. The fingerprint reader is connected via UART or USB.
Specifications:
Supply voltage: 3.3-5V DC
Signal voltage: 3.3-5V
Communication:
..
€47.00
Ex Tax:€38.84
Model: WS-17539
Brand: Waveshare
A HAT for the Raspberry Pi with which the current, voltage and therefore also the power can be measured on 4 different channels. The module also supports bi-directional current, which means that the IN+ and IN- may be reversed. The voltage is measure..
€18.00
Ex Tax:€14.88
Model: WS-20232
Brand: DFRobot
This environment sensor module from Waveshare is made for the Raspberry Pi Pico or other microcontrollers that use the same pin layout. This allows you to measure movement, temperature, humidity, light and air quality.
Note: No Raspberry Pi Pico i..
€35.00
Ex Tax:€28.93
Model: WS-26184
Brand: Waveshare
This camera can be used to replace the standard camera on the Raspberry Pi Camera V2 module. The module is compatible with all Raspberry Pi boards.
Note: The included cable is only suitable for use with the Raspberry Pi 5 and Rasperry Pi Zero...
€15.00
Ex Tax:€12.40
Model: WS-26185
This camera can be used to replace the standard camera on the Raspberry Pi Camera V2 module. The module is compatible with all Raspberry Pi boards.
Note: The included cable is only suitable for use with the Raspberry Pi 5 and Rasperry Pi Zero...
€17.00
Ex Tax:€14.05
Model: WS-16507
Brand: Waveshare
A camera module from Waveshare that is suitable for Jetson Nano/Xavier mini computers...
€17.50
Ex Tax:€14.46
Model: WS-21635
Brand: Waveshare
A USB camera from Waveshare with automatic focus. The camera is compatible with Windows, Raspberry Pi and Jetson Nano, among others...
€26.25
Ex Tax:€21.69
Model: WS-21653
Brand: Waveshare
A camera module with a wide lens from Waveshare. The module is compatible with all Raspberry Pi boards...
€24.50
Ex Tax:€20.25
Model: WS-21797
Brand: Waveshare
A camera module with a wide lens from Waveshare. The module is compatible with all Raspberry Pi boards...
€26.00
Ex Tax:€21.49
Model: WS-21583
Brand: Waveshare
A camera module with a wide lens from Waveshare. The module is compatible with all Raspberry Pi boards...
€24.50
Ex Tax:€20.25
Model: WS-31671
Brand: Waveshare
A USB camera module with a wide lens from Waveshare...
€26.25
Ex Tax:€21.69
Model: WS-3707
Brand: Waveshare
A Real-Time Clock module with I2C "pass-through". This module has both a male and female headers for the I2C connections, which provides more flexibility.
Specifications:
Supply voltage: 1.8-5.5V DC
Signal voltage: 1.8-5.5V
Communication..
€4.00
Ex Tax:€3.31
Model: WS-19426
Brand: Waveshare
An RTC module that can be placed as a HAT on a Raspberry Pi Pico (or other microcontroller with the same form factor).
Note: No Raspberry Pi Pico is included...
€13.00
Ex Tax:€10.74
Model: WS-10344
Brand: Waveshare
A Waveshare-made camera for the Raspberry Pi.
Specifications:
Sensor: OV5647
Aperture: 2.35
Focal Length: 3.15mm
Field of view: 160°
Maximum resolution photo: 5MP (2560 x 1960 pixels)
Maximum movie resolution: 1080P (19..
€21.50
Ex Tax:€17.77
Model: WS-20903
Brand: Waveshare
With this module a fingerprint can be read with a Raspberry Pi, Arduino or other microcontroller. The fingerprint reader is connected via UART...
€19.50
Ex Tax:€16.12
Model: WS-25553
A camera module that is compatible with LuckFox development boards...
€10.00
Ex Tax:€8.26
Model: WS-16864
Brand: Waveshare
With this HAT you provide your Raspberry Pi with various sensors that communicate via I2C. The HAT is designed for the Raspberry Pi Zero, but also works with other models. In addition, the module can also be used with other microcontrollers such as a..
€36.50
Ex Tax:€30.17
Model: DIYSCALE-5KG
A digital electronic scale based on the HX711 module with a 5kg load cell.
Specifications:
Input voltage 5V DC*
Diameter: 10 cm
Height: 3.5cm
* The module can be modified to work with 3.3V. Check this link for more information:&nb..
€7.00
Ex Tax:€5.79
Model: WMD1MHP303B
A barometric module/shield for the Wemos D1 Mini.
Works with I2C interface. Module can measure temperature and pressure.
Specifications:
Measuring range pressure: 300-1200 hPa
Measurement range temperature: -40-85 °C
Precision pres..
€3.50
Ex Tax:€2.89
Model: WMD1MBH1750FVISHIELD
A shield with a BH1750FVI light sensor for the (Wemos) D1 Mini.
The shield works with I2C and the I2C address is adjustable.(see PCB)
Specifications:
Range of light intensity: 1 - 65535 lx
50/60 Hz light noise filter function
Operates o..
€3.50
Ex Tax:€2.89