Model: AM2301-MOD
The AM2301 is a very accurate temperature and humidity sensor. The sensor is a lot more accurate than the DHT11, and comparable to the DHT22. The sensor is relatively large, but this makes it easier to mount.
See the manual under the "Downloads" t..
€6.00
Ex Tax:€4.96
Model: AM2320
A handy temperature sensor and humidity sensor...
€3.00
Ex Tax:€2.48
Model: AGS02MA
A gas sensor that can measure TVOC. The module communicates via I2C.
Specifications:
Supply voltage: 3.3 - 5.5V DC
Signal voltage: 3.3 - 5.5V (same as supply voltage)
Communication: I2C
I2C address: 0x1A
TVOC sensor:
..
€4.00
Ex Tax:€3.31
Model: AHT21B-MOD
A small temperature and humidity sensor in one.
See the following page for a library for this sensor: Adafruit AHTX0..
€3.00
Ex Tax:€2.48
Model: AHT25-MOD
A small temperature and humidity sensor in one.
See the following page for a library for this sensor: Adafruit AHTX0
Note: The pin spacing is not compatible with standard pin headers and DuPont connectors...
€3.00
Ex Tax:€2.48
Model: AM2122
A handy temperature and humidity sensor.
Pinout (left to right from the front):
VDD: Supply voltage
SDA: Serial Data (One-Wire)
GND: Ground
NC: Not connected
See the datasheet under the tab "Downloads" for more information.
See..
€4.00
Ex Tax:€3.31
Model: AM2315C
A handy temperature and humidity sensor.
See the following page for a library for this sensor: AM2315..
€13.00
Ex Tax:€10.74
Model: DHT20
A handy temperature and humidity sensor in one.
Pinout (left to right from the front):
VDD: Supply voltage
SDA: Serial Data (I2C)
GND: Ground
SCL: Serial Clock (I2C)
See the datasheet under the tab "Downloads" for more information..
€3.00
Ex Tax:€2.48
Model: HR202L
A humidity-sensitive resistor for measuring humidity.
Specifications:
Maximum voltage: 1.5V AC
Maximum power: 0.2mW
Operating frequency: 500Hz ~ 2kHz (1kHz recommended)
Measuring range: 20 - 95% RH
Accuracy: ±5% RH
Working temperat..
€1.00
Ex Tax:€0.83
Model: BME280MOD
A very compact barometer that works with I2C or SPI. The BME280 is an 3-in-1 module that can measure temperature, pressure and humidity.
For more information see the datasheet under the tab "Downloads".
The module can only be powered with..
€7.50
Ex Tax:€6.20
Model: BME280LVLCNV
A very compact barometer that works with I2C. The BME280 is an 3-in-1 module that can measure temperature pressure and humidty
For more information see the datasheet under the tab "Downloads".
This version includes a level converter and voltage..
€8.50
Ex Tax:€7.02
Model: BME680LVLCNV
This module has four sensors in one that can measure temperature, air pressure, humidity and air quality. The module has a built-in level converter making it easy to use with both 3.3V and 5V microcontrollers.
Specifications:
Supply voltage:..
€14.00
Ex Tax:€11.57
Model: BMP180
A very compact barometer that works with I2C. The BMP180 is the better successor of the BMP085.
The module can be supplied through the VCC pin with 3.3V or 5V. It also has a 3.3V output ("3.3" pin). The I2C only works with 3.3V and needs a level s..
€4.00
Ex Tax:€3.31
Model: BMP280
A very compact barometer that works via I2C or SPI. The BMP280 is the better successor to the BMP180 with buildin temperature sensor and pressure sensor.
For more information see the datasheet under the tab "Downloads".
The module can only be f..
€4.00
Ex Tax:€3.31
Model: BMP388
A very compact temperature and air pressure sensor (barometer). The BMP388 is the successor to the BMP280. The module has a built-in level converter making it easy to use with both 3.3V and 5V microcontrollers.
Specifications:
Supply voltage..
€7.50
Ex Tax:€6.20
Model: CCS811MOD
The CCS811 module is a digital gas sensor with metal oxide (MOX) gas sensor to measure "Volatile Organic Compounds" (VOCs) from the air.
This sensor is intended for indoor use in combination with a microcontroller via an I2C interface. The sensor ca..
€25.50
Ex Tax:€21.07
Model: CCS811HDC1080MOD
This module contains a CCS811 digital gas sensor and an HDC1080 humidity and temperature sensor. This sensor module is intended for indoor use in combination with a microcontroller via an I2C interface.
The CCS811 module is a digital gas sensor th..
€30.50
Ex Tax:€25.21
Model: DFROBOT-SEN0536
A CO2 sensor, humidity sensor and a temperature sensor in one of DFRobot...
€55.00
Ex Tax:€45.45
Model: DHT11
A handy temperature and humidity sensor.
Specifications:
Measurement range Humidity: 20% - 90% RH (0-50 °C temperature compensation)
Measurement range Temperature: 0 - +50 °C
Air humidity precision: ±5.0% RV
Temperature precision: ±2.0..
€2.50
Ex Tax:€2.07
Model: DHT22
A handy temperature and humidity sensor. This one is more precise than the DHT11.
Specifications:
Measurement range Humidity: 0 - 100% RH (0-50 °C temperature compensation)
Measurement range Temperature: -40 - +80 °C
Air humidity precisi..
€5.50
Ex Tax:€4.55
Model: DHT22MOD
DHT22 Module + Cables.
A handy temperature sensor and humidity sensor. This is a lot more accurate than the DHT11.
Humidity measurement range: 0% ~ 100% RH
Measuring range temperature: -40 ~ +80 °C.
Humidity accuracy: ±2.0% RH (typical),..
€6.00
Ex Tax:€4.96
Model: GY-MS5803-01BA
A very compact barometer and temperature sensor in one. The sensor chip is designed to perform underwater measurements and is therefore waterproof on top (note: the PCB itself is not water resistant).
See the following page for an Arduino IDE libr..
€15.50
Ex Tax:€12.81
Model: GY-MS5803-14BA
A very compact barometer and temperature sensor in one. The sensor chip is designed to perform underwater measurements and is therefore waterproof on top (note: the PCB itself is not water resistant).
See the following page for an Arduino IDE libr..
€21.50
Ex Tax:€17.77
Model: GY-MS5837-02BA
A very compact barometer and temperature sensor in one. The sensor chip is designed to perform underwater measurements and is therefore waterproof on top (note: the PCB itself is not water resistant). The built-in level converter makes it suitable fo..
€12.50
Ex Tax:€10.33
Model: GY-MS5837-30BA
A very compact barometer and temperature sensor in one. The sensor chip is designed to perform underwater measurements and is therefore waterproof on top (note: the PCB itself is not water resistant). The built-in level converter makes it suitable fo..
€19.50
Ex Tax:€16.12
Model: GY-SDC40
A compact CO2, humidity and temperature sensor with I2C interface.
See the following page for a library for this sensor: Sensirion I2C SCD4x Arduino Library..
€22.00
Ex Tax:€18.18
Model: GY-SDC41
A compact CO2, humidity and temperature sensor with I2C interface.
See the following page for a library for this sensor: Sensirion I2C SCD4x Arduino Library..
€29.50
Ex Tax:€24.38
Model: GY-SHT31-D
This is a very compact temperature and humidity sensor module...
€4.00
Ex Tax:€3.31
Model: M5STACK-U090
Brand: M5Stack
This is a barometric air pressure sensor module with a Grove connection for M5Stack. The module works via I2C communication.
Specifications:
Sensor: BMP280
Measuring range air pressure: 300-1100hPa
Air pressure resolution: 0.16hPa
..
€6.00
Ex Tax:€4.96
Model: M5STACK-A011-B
Brand: M5Stack
The M5Stack BTC Standing Base is a standard for the M5Core. With the standard you provide the M5Core with power. It also has a built-in SHT30 temperature and humidity sensor that works with I2C communication.
Specifications:
Input voltage: 5..
€10.00
Ex Tax:€8.26
Model: M5STACK-U103
Brand: M5Stack
A CO2 sensor, humidity sensor and a temperature sensor in one of M5Stack...
€37.50
Ex Tax:€30.99
Model: M5STACK-U104
Brand: M5Stack
A CO2 sensor, humidity sensor and a temperature sensor in one of M5Stack...
€48.00
Ex Tax:€39.67
Model: M5STACK-U001-C
Brand: M5Stack
The ENV III Unit is an upgrade of the ENV II and ENV Unit. This module has a temperature, humidity and air pressure sensor with a Grove connection for M5Stack.
The difference between the ENV III Unit and the ENV II Unit is that this one uses the Q..
€8.00
Ex Tax:€6.61
Model: M5STACK-K023-B
Brand: M5Stack
This kit consists of an M5Stack Basic with pedestal and a PM2.5 Base module. This module consists of a PMSA003 laser dust sensor. The supplied pedestal contains a SHT30 temperature and humidity sensor...
€67.00
Ex Tax:€55.37