- Availabilty: Directly available
- Model: PSBRIGHTPI
- SKU: 002068
With this kit you make a light module for the camera for the Raspberry Pi. The LEDs and headers must be soldered. The LED driver and I2C interface are pre-soldered.
The module uses an I2C interface, therefore it can also be used in combination with other microcontrollers including Arduino.
- 1x Bright Pi PCB
- 4x Bright white LEDs
- 8x Bright IR LEDs
- 1x 90 degree male header
- 1x DuPont connection cable
- 3x M2 12mm Nylon bolts
- 12x M2 Nylon nuts
Note: The camera is not included! This can be purchased seperately.
See the following page for instructions and to get started with the module: Getting Started