Pi Supply Raspberry White and IR Camera Light Module - DIY Kit

With this kit you make a light module for the camera for the Raspberry Pi. The LEDs and headers must be soldered. The LED driver and I2C interface are pre-soldered.

The module uses an I2C interface, therefore it can also be used in combination with other microcontrollers including Arduino.

Package contents:

• 1x Bright Pi PCB
• 4x Bright white LEDs
• 8x Bright IR LEDs
• 1x 90 degree male header
• 1x DuPont connection cable
• 3x M2 12mm Nylon bolts
• 12x M2 Nylon nuts

Note: The camera is not included! This can be purchased seperately.

See the following page for instructions and to get started with the module: Getting Started