- Availabilty: Directly available
- Model: MG996R
- SKU: 000832
A fairly powerful servo that is easy to control and largely compatible with the TowerPro MG996R servo. (but not from TowerPro)
There are a couple of pieces of plastic that you can mount on it, where you can then mount other things on.
No-load speed: 0.17 seconds/60 degrees (4.8V); 0.14 sec/60 degrees (6.0V)
Torque: 9.4kg · cm (4.8V); 11kg · cm (6.0V)
Rotation range: 180 degrees
Voltage range: 4.8V ~ 7.2V
Note: This servo can draw relatively high currents, especially with load. (up to approximately 2500mA at 6V at standstill) So choose a suitable power supply for the servo. It is not recommended to take the Arduino power.
Note: If the servo has less than 180 degrees range, the minimum (500us) and maximum pulse width (2500us) must be adjusted in the controller.