MG996R Servo

A fairly powerful servo that is easy to control and largely compatible with the TowerPro MG996R servo. There are a couple of pieces of plastic that you can mount on it, where you can then mount other things on.

Note: This servo can draw relatively high currents, especially with load (up to approximately 2200mA at 7.4V at standstill). So choose a suitable power supply for the servo. It is not recommended to take the Arduino power.

Note: If the servo has less than 180 degrees range, the minimum (500us) and maximum pulse width (2500us) must be adjusted in the controller.

Check the tab "Downloads" for more information and/or downloads.