LilyGO LILY Pi ESP32 - with 3.5 inch IPS Capacitive Touch Screen

The LilyGO LILY Pi is based on the ESP32 and has the form factor of a Raspberry Pi. This LILY Pi comes with a display with touchscreen and a built-in relay. It is easy to program via the Arduino IDE. The USB ports do not support the USB protocol but are connected directly to the GPIO pins of the LILY Pi

Specifications:

• Supply voltage: 5 - 12V DC (via DC jack) or 5V DC (via USB-C)
• Signal voltage: 3.3V
• Output voltage (USB ports): 5V DC
• Microcontroller: ESP32-WROVER (240MHz dual core processor)
  • Flash memory: 16MB
  • SRAM: 520KB
  • PSRAM: 8MB
  • Built-in Wi-Fi
  • Built-in Bluetooth
• USB to serial converter: CP2104 or CH9102 (drivers)
• Display:
  • Screen diagonal: 3.5 inch
  • Resolution: 480 x 320 pixels
  • Pixel colors: RGB
  • Type: IPS
  • Driver: ILI9481
• Touch screen:
  • Type: Capacitive
  • Controller: GT911
  • Communication: I2C
• RTC: PCF8563
  • Communication: I2C
• Built-in microSD card adapter
• Relay:
  • Maximum switching voltage: 30V
  • Maximum switching current: 2A (resistive load)
• DC Jack: 5.5 x 2.1mm
• Dimensions: 100 x 63 x 31mm

Package contents:

• 1x LilyGO LILY Pi
• 1x USB-A to USB-C cable
• 1x Detachable screw terminal 3p

See the following page for sample code: LilyGO LilyPi

Note: The USB ports are connected directly to the pins of the ESP32, so they cannot be used as standard USB ports.