Current and Voltage meter with segment display - 7-100VDC 10ADC

Simply connect to the cables whose voltage is to be measured.

Voltage range: 7V-100VDC
Power range: 0-10ADC
Installation dimensions: 46x27mm
Maximum thickness of mounting material: 3mm
Recommended installation thickness: 2mm

Note: If the thickness of the installation material is less than 2mm, then you have to glue the black housing into the installation material.

Cables are supplied with connectors.
The thin cable is intended to measure the voltage and the thick cable is intended to measure the current.
See the diagram in the illustrations and the explanation below about connecting this meter.

Connecting the thin wires:

• Red: positive/plus voltage
• Black: ground/min (Note: You do not have to connect this if you use the thick cables for the current measurement!)

Connecting the thick wires:

• Connect the thick black wire to the ground/min of your battery or other power supply and then connect all devices (previously connected to the same ground/min) to the thick thread.

Caution: Follow the instructions above correctly, otherwise it is possible that the current meter part breaks in this module because of a short circuit.

Installation instructions:

1. Carefully remove the PCB and screen from the black housing. For this, it is best to bend the black clip on the side of the connectors to the outside to remove the PCB. Note: after removing the PCB, the plastic plate (with "V" and "A" on it) is loose. It is best to separate these.
2. Install the housing on the material (if necessary with glue).
3. If necessary, replace the plastic diffuse plate (with "V" and "A" outwards).
4. Click the PCB and screen back in black housing. For this you first have to put the side without the connectors diagonally back into the housing and then the side of the circuit board with the connectors back on.