Kradex Enclosure 283x193x95mm - IP65 - Grey - Transparent - Z95JPH TM ABS

A universal enclosure to neatly build in your project. This variant has a separate gasket with which the contents can be well protected against water and dust.

Tip: Press the gasket into the edge of the lid and leave a small piece at the end before cutting it (about 2-3mm).
Then you can press the last piece in a bit, which provides better protection against water/moisture.

Note: The enclosure is marked as being made of PS. In reality, however, the enclosure is made of ABS. For technical reasons, the marking in the mold cannot be changed.

Check the tab "Downloads" for more information and/or downloads.