5V relay 4-channel low-active

A module with four relays on board.
This version works on 5V. The input works on 0V and 5V (Active low).
The relay therefore switches if there is a 0V signal on the input ("IN") and does nothing (not switched) with a signal of 5V.

Specifications:

• Voltage (control): 5V DC
• Current per relay (when switched on): ~70mA (~240mA total)
• Maximum voltage through relay: 250V AC or 30V DC
• Maximum current through relay: 10A (up to 240V AC) or 10A (up to 28V DC)

Connecting to the Arduino:

• Connect the GND to the GND of the Arduino
• Connect the Vcc to the 5V of the Arduino
• Connect the IN pin with the desired pin on the Arduino to control the relay