Small switch - 90 Degrees - Extra Strong

A switch that you can put on a printed circuit board.
This switch is very small and not suitable for high currents.
There are 3 pins available. The middle pin is connected with the pin on the side where the switch is set.
This variant is turned 90 degrees so you can switch something from the side. In addition, it has two additional pins for extra sturdy mounting on a printed circuit board.

Suitable for 30VDC - 0.3A.

See the images for more specifications.

Note:the pin distance of this switch is 2.0mm. This is therefore not suitable for use with experimental circuit boards. They usually have a pin distance of 2.54mm.