Arduino Modulino Buttons
- Availability: Directly available from warehouse in Eindhoven
- SKU: 007136
€9.50
Ex Tax: €7.85
Your shopping cart is empty!
This Arduino Modulino module uses an STM32 chip to read 3 buttons and control 3 LEDs via I2C, and can easily be chained to other QWIIC compatible modules.
See the following page for more information: Wiki
Check the tab "Downloads" for more information and/or downloads.
Datasheet: 007136_ABX00110-datasheet.pdf
| General | |
| Brand | Arduino |
| Manufacturer model/SKU | ABX00110 |
| Norm conformity | CE FCC RoHS |
| Minimum operating temperature [°C] | -40 |
| Maximum operating temperature [°C] | 85 |
| General physical appearance | |
| Main color | Blue |
| Weight [g] | 5 |
| Dimension X [mm] | 41 |
| Dimension Y [mm] | 25 |
| Mounting options | Mounting hole(s) |
| Diameter mounting hole(s) [mm] | 3.2 |
| Form factor | Module (general) |
| General electrical properties | |
| Minimum supply voltage [V DC] | 2 |
| Maximum supply voltage [V DC] | 3.6 |
| Minimum IO-pin input voltage [V] | 2 |
| Maximum IO-pin input voltage [V] | 3.6 |
| IO-pin output voltage [V] | Equal to I2C bus voltage |
| Communication | |
| Hardware interface(s) | I2C Digital |
| Default I2C address | 0x7C |
| Adjustable I2C address | Yes |
| Built-in pull-up resistor(s) [kΩ] | None |
| Switch | |
| Switching method | Physical (sensor switch) |
| Switch type | Push |
| Number of channels/gangs | 3 |
| Number of fixed (on-off) positions per channel | 1 |
| Number of spring-back (reset) positions per channel | 1 |
| Connectors | |
| Power supply connector(s) | JST-SH (compatible) male Through hole solder pin(s) (2.54mm) |
| IO-connector(s) | JST-SH (compatible) male Through hole solder pin(s) (2.54mm) |
| Package contents | |
| Package contents | 1x Modulino Buttons 1x JST-SH cable (5cm) |