Standard 5050 RGB LED Strip - 300 LEDs 5m - 12V

A standard RGB LED strip of which the red, green and blue LEDs are supplied with voltage via the separate R, G, B and 12V pins.
This LED strip can only be one specific color with the aid of the separate RGB colors. (the LEDs are not individually addressable)

Specifications:

• Voltage: 12V
• Power consumption: 1A/meter (5A total at 12V)
• Total power required: 60W on 12V (for 300 LEDs)
• LED type: 5050 (SMD LED)
• Strip length: 5 meters
• Width strip: 10mm
• Divided into cut-out pieces every 5cm consisting of 3 LEDs
• Bottom of the strip is provided with an adhesive layer for convenient installation
• Number of LEDs/meter: 60 (300 total)
• Beam angle of LEDs: 120 degrees
• Water resistance: not waterproof
• Temperature range: -20°C to 50°C

Example to use this LED strip in combination with Arduino:   RGB Led Strip controlled by Arduino   (as mosfet you can Use IRF640)

Note: The maximum power (and therefore brightness) can only be achieved if new power is offered per meter. (Branches from the same power supply) The copper on the LED strip is not thick enough to useit at full power.