RobotDyn Nano V3.0 IO and Wireless Shield

This board gives you the possibility to connect various wireless boards to your Arduino Nano.
The board supports the nRF24L01(+), ESP8266 ESP-01(S), APC220 and xBee modules.

In addition, the board has separate pins with power supply next to it, making the board plug and play.
The board also has a 5V and 3.3V voltage regulator so you can power the Nano and wireless module via the DC-jack connection.

The switch on this shield allows the xBee module (if connected) to communicate with the USB-to-serial converter or with the microcontroller.

Specificaties:

• Input voltage (DC-Jack): 7-12V DC
• Current (max, DC-Jack): 500mA

See the images for the pinout and the attachment for the schematic of this board.

Note: With this board only one xBee/APC220/ESP-01(S) module can be used at the same time. These wireless boards all use the RX and TX pins of the Nano.

Check the tab "Downloads" for more information and/or downloads.