M5Stack M5Stamp Pico Mate DIY Kit - ESP32-PICO-D4

The M5Stamp Pico Mate is a development board from M5Stack, based on an ESP32-PICO-D4, with a very compact design. Thanks to the ESP32 chip, this module has Wi-Fi and Bluetooth. The M5Stamp Pico is easy to program in UIFlow, Arduino and MicroPython. The ESP programmer is included in this DIY Kit.

Specifications Pico Mate:

• Supply voltage: 5V DC (via 5V pin) or 3.3V (via 3V3 pin)
• GPIO voltage: 3.3V
• Microcontroller:
  • Chip: ESP32-PICO-D4
  • Clock frequency: 240MHz
  • Processor cores: 2
  • SRAM: 520kB
  • Flash memory: 4MB
  • Built-in Wi-Fi
  • Built-in Bluetooth
  • Number of GPIO pins: 12
  • Number of PWM pins: 11
  • Number of analog input pins (ADC): 3
  • Number of analog output pins (DAC): 2
• Grove interfaces: 1
  • 1x GPIO
• Built-in 2.4GHz 3D antenna
• Built-in programmable RGB LED SK6812 (GPIO27)
• Built-in programmable button (GPIO39)
• Operating temperature: 0 - 60°C
• Pin distance: 2.54mm
• Dimensions: 18 x 24 x 4.4mm

Specifications ESP32 Downloader:

• USB to serial converter: CP2104 or CH9102F (drivers)
• Connector: USB-C female
• Baud rate: 300bps - 2Mbps
• Dimensions: 33 x 16 x 3mm

Package contents:

• 1x M5Stamp Pico
• 1x ESP32 Downloader
• 1x Mounting bolt
• 1x Plastic cover
• 1x Male header set
• 1x Female header set
• 1x Grove connector 90°
• 1x Allen key
• 1x Sticker

See the following page for more information: M5Stack M5Stamp Pico Mate.