16-kanaals I2C PWM-Servo Controller - PCA9685 - Separate headers

With this 16-channel pwm/servo control you can easily control servo's or LEDs via I2C.
This module is based on the PCA9685 servo control of Adafruit and roughly corresponds:
Adafruit 16-Channel 12-bit PWM/Servo Driver - I2C interface - PCA9685

Specifications:

• Voltage Vcc pin: 3-5V
• Voltage signal pins: 3-5V
• Maximum voltage V+ pin: 6V (connection via terminal block)
• PWM resolution resolution: 12-bit
• 6 solder pads to set the I2C address (62 combinations possible)
• Can be connected in a chain to control up to 992 outputs via I2C
• Reverse polarity protection on the V+ pin (Warning: Maximum current via terminal block is 500mA*)
• Four 3mm holes for mounting
• Several male pin headers are included with a terminal block

For more information, see the above link to Adafruit.

* Note: This module is based on an old Adafruit design where the transistor for polarity protection is relatively small. If you use a combination of servo motors that together use more than 500mA, you must use the V+ header pins on the sides to supply the servo motors with power. If the current exceeds 500mA, the transistor on the module may burn out.