BIGTREETECH RAMPS 1.6+ - 3D Printer motherboard

The RAMPS 1.6+ 3D printer motherboard from BIGTREETECH is suitable to use in combination with. an Arduino Mega and up to five stepper drivers (X, Y, Z, E0, E1). In addition, this motherboard has many other connections for LCD, Heated bed, End stops, etc.
The RAMPS 1.6+ is based on Marlin v1 software.

Specifications:

• Voltage (max): 12 - 35V DC
• Fuses (self-resetting) for heated bed and other electronics
• Supported:
  • 5 Stepper drivers (and therefore 5 stepper motors)
  • 3 End stops
  • 1 Heated bed
  • 1 Fan
  • 2 Extra heating connections (for a.o. hotend)
  • 3 temperature sensors
  • LCD screen connection
  • 4 Servo connections
• Reset button present
• Reset connection available for external reset option
• I2C Connection available
• Extra digital I/O pins available

Connection SPI for Stepper Drivers. This requires the supplied 2p Jumpers (see image 5):

• Connect pin 1 to 11 (MOSI)
• Connect pin 2 to 12 (SCK)
• Connect pin 3 to 5 (CSN)
• Connect pin 4 to 6 (MISO)

Connection STAP/DIR for Stepper Driver. This requires the supplied 2p Jumpers (see image 5):

• Pin 11, 12 and 5 represent MS1, MS2 and MS3
• Pin 8, 9, 10 stands for VCC
• Check the details of your Driver for which pins you need to connect

Package Contents:

• 1x Ramps 1.6+
• 1x Cooling block
• 1x 2p Jumper Set

Check out this link for more information on Hardware, Firmware, Wiring and more: BTT_RAMPS1.6+. There are also plenty of videos about this 3D print board on YouTube, for example.

Note: The heatsink should be placed at the top of the board, over the black side of the MOSFETs.

Please note: No Arduino Mega is included. An Arduino Mega (or compatible version thereof) is required for this motherboard to work.