RFID Card Reader Module 125KHz - RDM6300
- Availability: Directly available from warehouse in Eindhoven
- SKU: 005426
€4.50
Ex Tax: €3.72
Your shopping cart is empty!
With this RFID card reader you can read cards/tags for your project. The data can be read via UART. While sending the serial data, pin J1 is pulled up and thus gives an indication of a successful card/tag reading. At the same time, pin J2 is also activated, but this is an open-drain pin (so it is pulled down) with which a small load can be switched if necessary.
| General | |
| Brand | No brand |
| General physical appearance | |
| Main color | Green |
| Weight [g] | 6 |
| Dimension X [mm] | 43 |
| Dimension Y [mm] | 40 |
| Form factor | Module (general) |
| General electrical properties | |
| Minimum supply voltage [V DC] | 3.3 |
| Maximum supply voltage [V DC] | 5 |
| IO-pin output voltage [V] | Equal to supply voltage |
| Maximum IO-pin sink current [mA] | 100 (J2) |
| Communication | |
| Hardware interface(s) | UART |
| Default baudrate | 9600 |
| Wireless communication | |
| Interface(s) | RFID |
| RFID chip/SoC | RDM6300 |
| Supported RFID protocols | EM4100 (compatible) |
| RFID frequency [MHz] | 0.125 |
| RDIF read/write | Reading |
| Connectors | |
| Power supply connector(s) | Through hole solder pin(s) (2.54mm) |
| IO-connector(s) | Through hole solder pin(s) (2.54mm) |
| RFID antenna connector | Built-in antenna |
| Package contents | |
| Package contents | 1x RFID Card reader 1x Pin header male 5p |