ESP-PROG - Programmer for ESP32 and ESP8266

This ESP Programmer is a handy module for programming and debugging an ESP32 or ESP8266. In addition, the JTAG debugging function is available for ESP32. The programmer is easy to connect to a computer using the Micro USB port. This ESP programmer has an FT2232HL USB to serial converter to ensure that communication can be made between the computer and the module (make sure that a driver is installed for the FT2232HL on the computer). This board is also adjustable in voltage. With the 2p jumpers you can easily switch between 3.3 and 5V for both the JTAG and Programming interface.

Specifications:

• USB to serial converter chip: FT2232HL
• Micro USB connection for connection to computer
• JTAG and Programming female header, both 1.27mm and 2.54mm interface available
• Using 2p jumpers is for both the JTAG and Programming interface, 3.3V or 5V adjustable
• Built-in reset and boot button
• Suitable for ESP32 and ESP8266
• Dimensions: 73.4x25.1mm

Package contents:

• 1x ESP Programmer
• 1x JTAG interface cable (1.27mm)
• 1x Programming interface cable (1.27mm)

See the following pages for more information and debug examples: Introduction to the ESP-Prog Board en ESP-Prog