PET filament with carbon fiber mixed into it. A disadvantage of this filament is that it is rougher which causes a standard brass nozzle to wear faster. It is therefore recommended to use with a nozzle made of hardened steel. In addition, it is not recommended to use nozzles with a diameter smaller than 0.6mm due to the sensitivity to clogging.
Note: This product can not be returned if the sealed packaging has been opened.
The most effective method to unclog a nozzle is a cold pull. Click here for instructions. Sometimes, however, a nozzle can already be unclogged with the help of a thin needle. These are often included with a 3D printer.
Doesn't it work? Then it is best to replace the nozzle.
If you have a question or problem regarding a product, please contact us by using one of the buttons below.
Merge with the product from the cart?The main product of the kit has already been added to the cart. Merge with the product from the cart or add the kit to the cart?
Kit
Customize kit or add to cart?You can customize the kit.
Kit
Kit
Merge with the product from the cart?The main product of the kit has already been added to the cart. Merge with the product from the cart or add the kit to the cart?