Shipping Rate

The shipping costs are based on weight, volume, delivery address and subtotal of the order.
Indication of shipping costs:

Standard mail*: €2.50
Parcel Basic NL: €5.95 (free from €100)
Parcel International: See link below
Pickup in Eindhoven: €0.00

*The system will automatically decide if standard mail is possible. If not, then only Parcel and Pickup are available.
See this page for extra shippings options and explanation about the shipping costs: Shipping

LilyGO TTGO T8 ESP32-S2 - with 1.14 inch TFT Display

LilyGO TTGO T8 ESP32-S2 - with 1.14 inch TFT Display

Quick Shipping

Ordered before 17:00 on a business day? We ship the same day!

Model: LILYGO-H445
SKU: 003176
Availability: In Stock
€16.00 Ex Tax: €13.22
Stock Indication:
Quantity: Add to Cart

This TTGO module from LilyGO is a microcontroller based on an ESP32-S2 chip. The board has a USB-C connection with which it can be programmed and/or powered (USB-C cable not included). In addition, this module also has a TFT display and a microSD card adapter.


  • Supply voltage:
    • USB-C: 5V DC
    • 5V pin: 5V DC
    • V3V pin: 3.3V DC
    • Battery: 3.7-4.2V DC
  • Maximum input current: 1A
  • GPIO voltage: 3.3V*
  • ESP32-S2 chip:
    • Flash memory: 4MB
    • PSRAM: 8MB
    • SRAM: 320KB
    • Built-in Wi-Fi
  • USB to serial converter: CH340C
  • Built-in display:
    • Diagonal: 1.14 inch
    • Resolution: 240x135
    • Type: TFT
    • Driver: ST7789
  • Built-in microSD card adapter
  • Built-in Li-ion/Li-Po battery charging circuit:
    • Chip: TP4054
    • Maximum charging current: ~500mA
  • Battery connector: 2p Molex Picoblade
  • Dimensions: See images

CH340 drivers:

Package contents:

  • 1x LilyGO TTGO T8 ESP32-S2 - with 1.14 inch TFT Display
  • 1x Battery cable
  • 1x Male header set

Note: The ESP32-S2 does not yet have official support via the Arduino IDE. Programming via the Arduino IDE is possible with extra steps, however not all code will work. See the following page for more information: ESP32-S2 Arduino IDE Setup

*Note: The pins on the board are directly connected to the ESP32 chip and are therefore only suitable for 3.3V signals.

There are no reviews for this product.

Write a review

First Name:

Your email from your order: (will not be exposed)

Your Review:Note: HTML is not translated!

Rating: Bad           Good