Categories
Reviews

Shipping Rate

The shipping costs are based on weight, volume, delivery address and subtotal of the order.
Indication of shipping costs:


Standard mail*: €2.50
Parcel Basic NL: €5.95 (free from €100)
Parcel International: See link below
Pickup in Eindhoven: €0.00 - €1.00**


*The system will automatically decide if standard mail is possible. If not, then only Parcel and Pickup are available.
** Temporarily due to COVID-19 based on order amount.

See this page for extra shippings options and explanation about the shipping costs: Shipping

LilyGO TTGO T-Beam - LoRa 868MHz - NEO-M8N GPS - ESP32

LilyGO TTGO T-Beam - LoRa 868MHz - NEO-M8N GPS - ESP32

Quick Shipping

Ordered before 17:00 on a business day? We ship the same day!

Model: LILYGO-H261
SKU: 002691
Availability: In Stock
... Piece(s) Sold
€26.00 Ex Tax: €21.49
Stock Indication:
Quantity: Add to Cart

The TTGO T-Beam from LilyGO is a microcontroller based on an ESP32 including a built-in SX1276 LoRa chip and a NEO-M8N GPS module. The CP2104 USB to serial converter makes it easy to program, even as an Arduino. The board has a micro USB connection with which it can be programmed and/or powered (micro USB cable not included) . 

Specifications:

  • Supply voltage: 3.3V DC or 5V DC
  • GPIO Voltage: 3.3V*
  • ESP32-D0WD-Q6 chip (240Mhz dual core processor)
    • Flash memory: 4MB
    • SRAM: 520KB
    • PSRAM: 8MB
    • Built-in Wi-Fi
    • Built-in Bluetooth
  • SX1276 LoRa chip
  • LoRa frequency: 868MHz
  • NEO-M8N GPS chip
  • Built-in Li-ion/Li-Po battery charging circuit: AXP192 chip can charge up to 1.4A
  • Built-in push button (IO38)
  • Built-in on/off button
  • Built-in 1x 18650 battery holder (battery not included)
  • PCB dimensions: 100.1x32.8mm

Package contents:

  • 1x LilyGO TTGO T-Beam V1.1
  • 1x LoRa antenna 868MHz 
  • 1x GPS Antenna
  • 1x Male header set

For more information and to get started with the board, see the following page: TTGO T- Beam

The T-Beam can also be use with the SoftRF software: SoftRF ESP32

To program the board with the Arduino IDE select the 'ESP32 Dev Module' in the board manager.

*Note: The pins on the board are directly connected to the ESP32 chip and are therefore only suitable for 3.3V signals.

There are no reviews for this product.

Write a review

First Name:


Your email from your order: (will not be exposed)


Your Review:Note: HTML is not translated!

Rating: Bad           Good