LED indicating the status of the amplifier (on/off)
Components with values are shown on the PCB
PCB format: 70x60mm
Note: At low voltages the LED will be less bright.
Contents of the kit:
1x PCB
4x 0.1uF (104) capacitor
2x 4.7uF capacitor
4x 47uF capacitor
3x 1000uF capacitor
2x 18 ohm resistor
3x 4.7k ohm resistor
8x 100k ohm resistor
1x 50k ohm potentiometer + knob
2x TDA2030
2x Heatsink + screw
1x 3mm LED
1x 1N4007 diode
1x 3.5mm female jack
3x Screw terminal
All locations of the components with value are listed on the PCB. Note: Instead of a 2200uF buffer capacitor a 1000uF capacitor is supplied. Solder this one to the location (C11) of the 2200uF capacitor.
Use a stable, CE-approved power supply with the correct voltage and sufficient power. It is recommended to use a power supply with a bit more power than the amplifier to provide headroom for current spikes.
If you have a question or problem regarding a product, please contact us by using one of the buttons below.
Merge with the product from the cart?
//
The main product of the kit has already been added to the cart. Merge with the product from the cart or add the kit to the cart?
Kit
Customize kit or add to cart?You can customize the kit.
Kit
Kit
Merge with the product from the cart?
//
The main product of the kit has already been added to the cart. Merge with the product from the cart or add the kit to the cart?